Part Installation Guides

  • GPS Skate Tracker Installation

    Wire the included JST connector wires to the input voltage. The black wire will go to P- of the BMS and the red wire will go to the batteries positive terminal Drill a hole in your enclosure for the switch. Then feed the wires through the enclosure and plug in the switch. Go to: https://www.usmob...
  • How to wire a BesTech BMS

    D223 The diagram below shows how to wire a BesTech D223 BMS with the extra connectors, charge port, and switch. To successfully install a BMS you should: Wire the B- wire shown in the bottom left of the diagram. This is very important that you do this first! Solder the switch to the two thing ...
  • Lacroix GPS Tracker

    Introduction: You will need a 2G GSM capable sim card to use the GPS module inside the Lacroix board. Here are some currently know providers: United States: US Mobile Data plan is $4.95/month Canada: Rogers  Europe: Vodafone Other countries: please contact your phone provider and ask if t...
  • Modular Pulley Installation

    First, gather all the required parts: Trucks Wheels Pulley Pulley Hub 1x Standard and 1x Exteneded Bearing 5x M4 Bolts 1.) Thread the locknut onto the axle By threading the locknut on the axle, you put 'teeth' marks in the nylon portion that allow you to install it in reverse. You only need ...